Add/remove Clamps
It is very common the need of multiple clamps in order to completely machine a job.
In this case, FCS System requires to define more than one set of holes: Guideline 4.0 manages this occurence giving you the possibility to define different clamping environments, each one having its own setup (base gauge, orientation, components).
To create a new environment, click on "Add Clamp" icon on the clamp navigator tree: Guideline 4.0 will add a new one and ask for a base gauge, as at the beginning.
Each clamp can be activated by clicking it on the tree.
To remove the active clamp, just press the icon beside (see picture below)
