Selection Behind ![](lib/NewItem351.png)
It's a filter to select the right object in the graphical area. It calls out the toolbar below:
![](lib/NewItem352.png)
If more than an object of each kind could be selected (meaning that they are difficult to distinguish or are in a tricky position), a series of icons becomes available under Selection Behind to finally pick the desired object. Pressing the icons one by one, the pre-selected object will be highlighted.
![](lib/NewItem364.png)
Advanced Selection ![](lib/NewItem366.png)
Box and Weight ![](lib/NewItem373.png)
Bly calculates for each model and assemby its Bounding Box, which is defined as the smallest parallelepiped including the model. This command is a duplicate of "Show Bounding Box", more info can be found here.
Change Color and Transparency ![](lib/NewItem375.png)
Gives the possibility to change color and transparency of the selected component(s). The following window is displayed:
![](lib/NewItem374.png)
Reset Color and Transparency ![](lib/NewItem376.png)
Restores the previously set color and transparency of the selected component(s).
Isolate ![](lib/NewItem377.png)
Hides all assembly's components but the one selected.
|